Matrix Software, cont’d
CrossPoint 450 Plus and MAV Plus Switchers • Matrix Software5-4
Using the software
Many items found in the Matrix Switchers Control Program are also accessible via
front panel controls (see chapter 3, “Operation”) and under SIS control (see chapter
4, “Programmer’s Guide”). The Matrix Switchers Help Program provides
information on settings and on how to use the control program itself.
1. To run the Matrix Switchers Control Program, double-click
on the Matrix Switchers Control Program icon (shown at
right) in the Extron Electronics group or folder.
The Comm Port Selection window (figure 5-3) appears.
Figure 5-3 — Comm port selection window
2. Choose either the comm port that is connected to the CrossPoint 450 Plus or
MAV Plus switcher’s serial port, IP [LAN], or Emulate.
If you selected a comm port, check the baud rate displayed in the comm
port selection window. If you need to change the baud rate, click on the
Baud button and double-click on the desired baud rate.
Available rates are 9600, 19200, 38400, and 115200. The default is 9600.
Click Ok and proceed to step 4.
If you selected IP [LAN], click Ok and proceed to step 3.
If you selected Emulate, click Ok and see “Using emulation mode” on
page 5-22.
3. If you selected IP [LAN] in step 2, the IP Connection window appears
(figure 5-4).
Figure 5-4 — Address and password entry
