ADCP-75-210 • Issue 1 • March 2007
Page 32
© 2007, ADC Telecommunications, Inc.
• (Pad mount only) Four 1/2 in. diameter galvanized steel bolts with four lock washers, four
flat washers, and four concrete anchors (see Figure 29 on Page 41)
• 3M 8426-9M cold shrink
• 3M Skothkote Electrical Coating 14853
• Ten Type N plugs (CommScope PN: 540ANM or equivalent)
• Coaxial cable (CommScope PN: FXL540OPE or equivalent)
• Electrician’s tape
• Water seal
• Electrical conduit
• Conduit fittings
• Connector sealant material
• Panduit LLCF6-14B-L or equivalent (X2)
• Two-hole compression lug terminal for #6 AWG wire
• Ground rod
• Connector for attaching #6 AWG grounding wire to approved ground source
The following tools are required to perform this procedure:
• Torque wrench
• Drill
• Drill bit (appropriate for pole width and 3/4 in. bolts)
• 7/16 in. open-end wrench
• Compression pliers for #6 AWG grounding lug
• Wire cutters
• Wire strippers
• Conduit cutter
• Conduit bender
2.4 Site Preparation
This section describes site preparation for installation and is presented only as a guideline for a
typical RAN installation.
2.4.1 Space Requirements
When an installation site for the RAN is selected, either on a utility pole or concrete pad, care
must be exercised to ensure that the site provides adequate space and clearance to accommodate
the current installation and any future upgrades. Table 17 gives RAN dimensions.
