A SERVICE OF

logo

2-134
SET MODULE CABLE_IMPEDANCE
SET MODULE
CABLE_IMPEDANCE
Use the SET MODULE CABLE_IMPEDANCE command to set the impedance level
for Token Ring module lobe ports. This command is available for the 3Com
ONline 20-Port Token Ring Module.
The impedance level for unshielded cable is usually 100 ohms. The impedance
level for shielded cable is usually 150 ohms.
Format
Example
The following command sets the cable impedance of the module in slot 1 to
100 ohms:
CB5000> set module 1.1 cable_impedance 100ohm
Cable impedance set to 100 OHM.
Related Command
SHOW MODULE
slot.
1
Selects a module to set impedance levels.
impedance Sets the impedance level. Valid values are:
100ohm
150ohm
set module
impedanceslot.
1
cable_impedance