Filter
Top Products
19
Models C810 & C812 Operating Procedures
Step 2
Use the wiper squeegee to clean the release
material sheet on the upper platen. Use a diagonal
motion to clean the sheet. Hold the handle at a slight
upward angle with the wiper end facing downward.
Note: Do not use excessive pressure when wiping
the release material sheet with the squeegee. Using
excessive pressure can scratch or tear the release
material sheet.
Figure 32
Step 3
Using the wiper squeegee, push the grease at the
rear of the lower grill surface into the grease can.
DO NOT use the grill scraper for this step.
Step 4
Use the grill cloth to clean the back splash plate and
bullnose areas as needed during operation.
Note: To increase the life of the release material
sheet, wipe it with a damp, folded grill cloth a
minimum of four times every hour.
CAUTION: The upper platen surface is
very HOT! To prevent burn injuries, use extreme
caution when wiping the release material sheet.
Daily Cleaning Procedures
Note: The three platen Model C810 has been
selected to illustrate the step-by-step procedures.
For grills equipped with less than three platens,
perform the following steps as appropriate for your
grill platen configuration.
Step 1
Raise the upper platen to the OPEN position by
pressing the red RAISE button.
Figure 33
CAUTION: Never use force to raise the
upper platen. Damage to components may
result. Only use the RAISE button to open the
upper platen!