Filter
Top Products
10
Models C810 & C812Operating Procedures
Section 6 Operating Procedures
The Model C810 has three independent upper
platens. The Model C812 has two independent
upper platens. These grills are capable of cooking a
variety of products and feature two cooking options.
They provide all of the features of a flat grill, as well
as the advantages of two-sided cooking.
Note: The three platen Model C810 has been
selected to illustrate the step-by-step procedures.
For grills equipped with less than three platens,
perform the following steps as appropriate for your
grill platen configuration.
Daily Opening Procedures
Before operating the grill, the release material
sheets must be installed on the upper platens.
Perform the following steps for installing release
material sheets:
CAUTION: Make sure the grill is COOL
before attempting to install or remove release
material sheets.
Step 1
Slide the release sheet retainer through the hemmed
end of the release material sheet.
Figure 5
Step 2
Hook the release sheet retainer on the release
material shoulder screws at the top of the upper
platen.
Figure 6
Step 3
Hold the non-hemmed end of the release material
sheet. Gently pull the sheet tight, wrapping it around
the platen in a side-to-side manner.
Figure 7
Note: Check the alignment of the release material
and make sure it fits smoothly over the upper platen.