Filter
Top Products
11
Models C810 & C812 Operating Procedures
Step 4
Place the release material clips over the release
material sheet. Press them into place over the
release material bar at the top of the platen.
Figure 8
Step 5
Check the tightness of the release material against
the upper platen.
Figure 9
Note: Installing the release material sheets too
tightly may cause premature failure of the sheet.
Step 6
Repeat steps 1 through 5 f or the remaining
upper platens.
Note: It is not necessary to change the release
material if small pin holes develop.
Note: Rotate and reverse the release the material
sheets on a daily basis.
The release material must be changed when:
S Product sticks to the release material.
S Carbon builds up, causing problems in taste
or appearance.
S There is a tear in the release material in the
cooking area.
Figure 10
S The r elease material substance is worn from
the release material sheet.
Note: Temperature checks should only be
conducted with the release material sheets
removed.
Note: Rotate and reverse the release material
sheets on a daily basis.