Filter
Top Products
Additive Feeders Chapter 8: Appendix 52 of 55
8-4 Returned Material Policy
Credit Returns
Prior
to the return of any material authorization must be given by the manufacturer. A
RMA number will be assigned for the equipment to be returned.
Reason for requesting the return must be given.
ALL
returned material purchased from the manufacturer returned is subject to 15% ($75.00
minimum) restocking charge.
ALL
returns are to be shipped prepaid.
The invoice number and date or purchase order number and date must be supplied.
No credit will be issued for material that is not within the manufacturer’s warranty period
and/or in new and unused condition, suitable for resale.
Warranty Returns
Prior
to the return of any material, authorization must be given by the manufacturer. A
RMA number will be assigned for the equipment to be returned.
Reason for requesting the return must be given.
All
returns are to be shipped prepaid.
The invoice number and date or purchase order number and date must be supplied.
After inspecting the material, a replacement or credit will be given, at the manufacturer’s
discretion. If
the item is found to be defective in materials or workmanship, and it was
manufactured by our company, purchased components are covered under their specific
warranty terms.
8-5 Safety Tag Information
Additive Feeder Safety Tags
Read Operation Shear Hazard
and Installation Rotating Auger
Manual
High Voltage Earth Ground
Inside Enclosure
PE Protected Earth
Lifting Point Ground