Filter
Top Products
EN
1
10
USE
Control panel
Button Function Led
A Turns the lighting system on and off at maximum in-
tensity.
On/Off
Press and hold for 2 seconds to turn the lighting system
on and off at reduced intensity.
On/Off
B Turns the Motor off.
Press and hold for approximately 5 seconds to Lock /
Unlock the Keyboard, for example in order to clean the
surface.
The buttons turn light up one at a time in cycle.
C Turns the Motor on at Speed one. On/Off
D Turns the Motor on at Speed two. On/Off
E Turns the Motor on at Speed three. On/Off
F Activates/Deactivates intensive speed from any other
speed, including motor off. This speed is set to operate
for 10 minutes, after which the system returns to the
speed that was set before. Suitable to deal with
maximum levels of cooking fumes. Can also be
deactivated by pressing button B.
Flashes once a second.
Press and hold the button for approximately 5 seconds,
with all the loads turned off (Motor and Lights), to turn
the Activated Charcoal Filter alarm on/off.
Button G (Flashes twice)-Alarm Activated.
Button G (Flashes once)-Alarm Deactivated.
G 24H function
Starts the Motor at a speed that allows suction of 100
m3/h for 10 minutes per hour for 24h, after which the
Motor will stop. It cannot be activated if the Intensive
or Delay functions are in use.
On/Off
When the filters alarm is triggered, the alarm can be
reset by pressing and holding this button for
approximately 5 seconds.
These indications are only visible when the motor is
turned off.
B flashes two times.
When the procedure terminates, the indication shown
previously turns off:
Button G flashes, indicating the need to wash the metal
grease filters. The alarm is triggered after the Hood has
been in operation for 100 working hours.
Button G flashes, indicating the need to change the
activated charcoal filters, and also to wash the metal grease
filters. The alarm is triggered after the Hood has been in
operation for 200 working hours.
H Delay function
Activates/Deactivates automatic switch-off with a 30’
delay. Suitable to complete elimination of residual
odours. Can be activated from any position. It cannot
be activated if the Intensive or 24H functions are in
use.
On/Off
Press and hold the button for approximately 5 seconds,
with all the loads turned off (Motor and Lights), to turn
the Remote control on/off.
Button B (Flashes twice)-Remote control Activated.
Button B (Flashes once)-Remote control Deactivated.
R Remote control receiver.