Pride Mobility Rock 2 Wheelchair User Manual


 
18 www.pridemobility.com Kids UP Series
Shell Assembly and Mobility Base (Kids FAST)
The shell assembly and mobility base can be separated
for ease of lifting and transporting the wheelchair.
WARNING! Never remove the shell
assembly from the mobility base with
the child in the wheelchair or use
either assembly when it is not properly
attached.
WARNING! Ensure that the shell
assembly is properly attached to the
mobility base before placing the child
in the wheelchair.
To remove the shell assembly:
1. Engage the attendant wheel locks.
2. Ensure that the ACTIVE handle lever, which is
located on the front of the ACTIVE handle, is in the
OFF position (parallel to the ACTIVE handle). See
figure 14.
3. Remove the child from the wheelchair.
4. Lift upward on the front of the seat pan.
5. Lift upward on the hip angle lever.
6. Lift the shell assembly upward and out of the
mobility base.
To install the shell assembly:
1. Lower the shell assembly into the mobility base so
that the seat pivot bushings enter the alignment
slots. See figure 15.
2. Pull upward on the hip angle lever, adjust the shell
to the desired hip angle position, and engage the hip
angle lever. Check for proper pin engagement and
lever position.
3. Turn the ACTIVE handle lever to the ON position
(perpendicular to the ACTIVE handle) and cycle
the ACTIVE motion to ensure proper installation.
4. Apply forward pressure to the push handle, and turn
the ACTIVE lever to the OFF position (parallel to
the ACTIVE handle). See figure 14.
III. YOUR WHEELCHAIR
Figure 14. The Kids FAST ACTIVE Handle (OFF)
ACTIVE HANDLE LEVER
Figure 15. Installation of the Kids FAST Shell Assembly
PIVOT BUSHING
ALIGNMENT SLOT
ACTIVE HANDLE