Filter
Top Products
Go-Chair www.pridemobility.com 31
VII. OPERATION
Thermal Rollback
The VSI controller is equipped with a thermal rollback circuit. This circuit monitors the temperature of the controller, which
roughly translates to motor temperature. In the event that the VSI controller becomes excessively hot (above 140° F), motor
current (amperage) is reduced. For every degree above 131° F, the motor current limit is reduced by .55 amps. This reduces
your Go-Chair’s “power,” which could also reduce your Go-Chair’s speed. Once the VSI controller reaches 158° F, the
current output is reduced to zero and your Go-Chair will stop. This allows the electrical components and motors to cool
down. When the temperature returns to a safe level, your Go-Chair resumes its normal operation.
VSI Error Codes
The VSI controller is designed with the user’s safety as the prime consideration. It incorporates many sophisticated self-
test features which search for potential problems at a rate of 100 times per second. If the VSI detects a problem either in
its own circuits or in the travel chair’s electrical system, it may decide to stop the Go-Chair, depending on the severity of the
problem. The VSI is designed to maximize the user’s safety under all normal conditions. The table below identifies the
individual error codes. Error codes are displayed as a rapid flashing of the lights. If you get one of these error codes,
contact an authorized Pride Provider.
FLASHING LIGHTS DIAGNOSIS AND SOLUTION
1 The batteries need charging or there is a bad connection to the batteries. Check the
connections to the batteries. If the connections are good, try charging the batteries.
2 The left motor has a bad connection. Check the left motor connection.
3 The left motor has a short circuit to a battery connection. Contact an authorized Pride
Provider.
4 The right motor has a bad connection. Check right motor connection.
5 The right motor has a short circuit to a battery connection. Contact an authorized Pride
Provider.
6 The Go-Chair is being inhibited by the battery charger. Unplug the battery charger.
7 A joystick fault is indicated. Make sure that the joystick is in the neutral (center) position
before turning on the controller.
8 A controller system fault is indicated. Make sure that all connections are secure.
9 The parking brakes have a bad connection. Check the parking brake and motor
connections. Make sure the controller connections are secure.
10 An excessive voltage has been applied to the controller. This is usually caused by a poor
battery connection. Check the battery connections.