Filter
Top Products
18 www.pridemobility.com Go-Chair
MANUAL FREEWHEEL LEVERS
The Go-Chair has a manual freewheel lever on each motor. Manual freewheel levers enable you to disable the drive system
in order to push the chair.
WARNING! Do not use the Go-Chair while the drive system is disabled! Do not disable the drive
system when the Go-Chair is on an incline, as the unit could roll on its own, causing injury!
NOTE: The batteries will not charge in freewheel mode unless the battery box is removed from the power base.
NOTE: You must turn off the power before disabling the drive systems, otherwise you may get an error code on
the controller. To clear this code, turn off the controller and place the Go-Chair in drive mode. Then turn on
the controller. The error message should be cleared. If not, contact an authorized Pride Provider.
To engage or disengage the drive system:
1. Locate the levers on the rear section of the power base. See figure 7.
2. Push the two levers forward to enable the drive system.
3. Pull the two levers rearward to disable the drive system.
WARNING! It is important to remember that when your Go-Chair is in freewheel mode, the braking
system is disengaged.
ANTI-TIP WHEELS
The anti-tip wheels are an integral and important safety feature of your Go-Chair. Do not, under any circumstances,
remove the anti-tip wheels from your Go-Chair. See figure 7.
III. YOUR GO-CHAIR
Figure 7. Back of Power Base
ANTI-TIP WHEELS
MANUAL FREEWHEEL LEVERS