Filter
Top Products
Go-Chair www.pridemobility.com 23
V. COMFORT ADJUSTMENTS
NOTE: If the lever will not rotate to the fully closed
position, then turn the nut counterclockwise one-quar-
ter or one-half turn.
Armrest Width Adjustment
You can change each armrest’s width independently of the other.
NOTE: Changing the armrest width may increase the
overall width of your Go-Chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the
armrest receiver bracket. See figure 18.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.
Foot Platform Depth
To adjust the foot platform depth:
1. Remove the hardware from the footplatform bracket.
See figure 19.
2. Move the foot platform in or out to the desired depth.
3. Reinstall the hardware into the foot platform bracket
and tighten.
Controller Position
You can position the controller for either left-hand or right-
hand use.
WARNING! Do not place the controller
cable so that it can be pinched in the
seat frame or the power base frame.
To change the controller position:
1. Unplug the controller connector from the power base.
2. Cut the wire tie(s) securing the controller cable to the
armrest.
3. Flip up the armrest and loosen the setscrew. See figure 20.
4. Slide the controller out of the armrest.
5. Loosen the setscrew in the other armrest.
6. Place the controller in the other armrest.
7. Tighten the setscrew to secure the controller.
8. Use a wire tie to secure the controller cable to the armrest.
9. Plug the controller connector into the power base.
Figure 19. Foot Platform Depth
Figure 20. Controller Position
Figure 18. Armrest Width Adjustment
ARMREST KNOB
(LOCATED ON
SEAT FRAME)
SETSCREW