Filter
Top Products
17
How to Apply the Wrist Cuff
How to wrap the wrist cuff is one of the most important points for
correct measurement. Wrap the cuff snugly on your wrist.
• This monitor is preset to measure on your left hand when you
purchased it. If you desire to measure on your right hand, change
the mode to Right Hand measurement in setting.
• Wrap the wrist cuff over your skin.
• Please be careful not to catch the cuff of your shirt.
1. Place the wrist cuff over your left wrist with
your left thumb facing upward.
• Cover the wrist cuff by leaving clearance
of 1/2 inch (the clearance almost equal to the
width of an index finger) between the edge
of the wrist cuff and the bottom of the palm
as shown in the Figure to the right.
Check if the wrist cuff completely covers your
wrist as shown in the Figure to the right.
How to wrap the wrist cuff correctly (on left wrist)
16
How to Reset This Monitor
Reset Settings
Any change made in the Setting Mode is cancelled to restore the state at the
time of your purchase of the monitor.
• After initialization, be sure to set the date and time.
• The stored measurement values are not deleted. If you want to delete
them, execute All Memory Erasure.
1. Push the SET button while the power
is turned off.
Keep pressing the button until the Reset
Settings Screen is displayed.
2. Select YES or NO.
• The initial setting of the monitor is NO
at any time.
For selecting YES
Push the button and select YES.
If you push the SET button, a screen asking
Are You Sure is displayed for reconfirmation.
To set to YES, push the button again.
• To cancel, push the button.
If you select YES and push the SET button, all
settings are resumed to the state at the time of
your purchase and the display changes to the
Automatic Memory Screen.
• If you select NO and push the SET button,
the display changes to Automatic Memory
Screen under the present setting.
If you want to finish setting here, push the
START/STOP button to turn off the power.
Reset Settings Screen
Reset Settings YES Screen
Are You Sure YES Screen
Automatic Memory ON Screen
HEM-637 REV A 8188 1/26/06 1:41 PM Page 16