Filter
Top Products
9
Automatic Memory Setting
Automatic Memory Screen
Automatic Memory OFF Screen
1. Push the SET button while the power
is turned off.
Automatic Memory Screen is displayed
.
2. Select ON or OFF.
• The monitor is set to ON (to store) at time
of your purchase.
To set it to OFF, push the button.
• If you want to set to ON after setting it
to OFF, push the button.
3. Lock the setting.
If you are going to change other settings, push the SET button
to lock the setting.
• When you push the SET button, the display changes to the
Position Sensor Screen.
If you want to finish operation after locking the setting, push
the START/STOP button to turn off the power.
The monitor stores the measured values and the date and time of measurement,
which is helpful for the continuous blood pressure management.
However, if more than one person is expected to use this monitor, the measured
values of more than one person will be stored. In that case, setting the Automatic
Memory to OFF is recommended.
8
Battery Replacement
• High performance alkaline dry cell batteries (2 “AAA”) should be good
for approximately 300 readings.
• Battery life varies with ambient temperature. Battery life is shorter under
cold conditions such as during the winter.
• If the battery replacement symbol blinks while measuring or if pressure
is not applied when the START / STOP button is pressed, replace both
batteries (use the same brand).
• Holding the START / STOP button down may shorten battery life. To avoid
pressure on the button when transporting or storing, use the case provided.
• If the batteries have been replaced or removed, resetting of the date and
time is required.
• If you are not going to use this monitor for a long period of time (approximately
three months or more), remove the batteries.
• Do not use batteries not specified for this unit, worn and new batteries
together, or different brands of batteries together.
HEM-637 REV A 8188 1/26/06 1:41 PM Page 8