Filter
Top Products
2322
Memory Reset Function
Deletes all the measurement values stored in this monitor. Do not delete them
in a normal situation.
• Please note, deleted measured values cannot be restored.
1.
Push the SET button while the power is turned off.
Keep pressing the button until Delete Data Screen
is displayed.
2.
Select YES or NO.
• The initial setting of the monitor is NO at any time.
For selecting YES
Push the button to set to YES.
If you push the SET button, a screen asking "ARE
YOU SURE?" is displayed for reconfirmation.
Push the button again to set to YES.
• To cancel, push the button to NO.
If you select YES in Are You Sure Screen following
Delete Data Screen and push the SET button, the
display changes to Data Deleted (Blank) Screen.
All the data in memory is deleted, and then the
power will be turned off.
• If you select NO and push the SET button, the data
in memory are not deleted and the display changes
to Reset Settings Screen
.
All Memory
Erasure Screen
All Memory
Erasure YES Screen
Are You Sure
YES Screen
Data Deleted
(Blank) Screen
How to Use The Memory Function
This monitor has a memory function to store up to 90 measurement results.
When you push the MEMORY button, the monitor displays the measured values
together with the date and time.
For the 91st measurement and onward, the measured values are deleted
from the oldest one.
To delete all the stored data, use the Setting Mode.
If the monitor is set to OFF in the Setting Mode, the monitor does not store
the measured values.
• The measured values are retained in memory even after the batteries are
removed for battery replacement.
1. Push the MEMORY button.
The latest measured values that are stored in
memory are displayed with the mark.
2. Check the memory.
Each time you push the button, the latest
measured values are displayed. If you push the
button, the screen moves backward
to the previous one.
• If you push the button while the latest
measured values are being displayed, the
oldest measured values are displayed.
• If you push the GRAPH button during the
memory display, you can see the measured
values of one week (including the called out
measured values) in graph display. If you
push the MEMORY button again,
the screen returns to the memory display.
3. Push the START/STOP button to turn off the power.
Date and
Time of
Measurement
HEM-637 REV A 8188 1/26/06 1:41 PM Page 22