Filter
Top Products
R-4108.A
REASSEMBLING PROCEDURE
REASSEMBLING PROCEDURE
< Reassembling
the
Slide Holder >
1)
Put
the axle supporter @ on the slide holder metal @ .
Place
the spiral
spring
@
on
the
metal
@ inserting its inner
and
into the
pin
hole of the metal @.
2) Insert the outer
and
of the spiral spring @ through the
pin
hole of the
washer
@.
C A)
(
8)
Fig.
7
3) Keeping the spiral spring, the inner end
in
the
pin
hoie, tum the washer @
in
the
arrow direction
(A) and to
be
positioned
as
shown
by
(B)
in
Fig.
7.
Then, place the slide
glass
retainer @
over
the washer @ inserting the spiral spring outer end
into the pin hole
of
the retainer @
and
fasten the screw
@.
(Fig. 8)
Fig.
8
4)
Fix
the above slide
glass
retainer assembly
on
the holder @. The latter
is
to
be
attached
to
the stage.
-8-