Filter
Top Products
R-4104.A
CARE
FOR
STARTING REPAIR
CARE
FOR
STARTING REPAI R
•
When
carrying the microscope, hold
its
arm
with
one
hand.
:rnd
1ts
base
with the other.
e For replacement and others
of
the lamp bulb,
do
not touch
it.
aiter putting out the lamp,
directly
with
the
fingers.
e
Wltlle
the
lamp
is
lighted, never bring
any
inflammable substances
such
as
alcohol, gasoline,
thinner, etc.
near
to
the
lamp housing.
• Take every caution
in
handling against shock.
•
Be
careful not to
leave
dust,
t1nger
marks, etc.
on
the
tenses,
lamp
bulb, etc.
e
Make
sure
of the power source
voltage
to
be
used
(for example: UNE
IOOV,
LAMP
6V,
20W),
referring
to
the
indication found
on
the transformer.
• Before replacing the
fuse
in
the transformer,
pull
out
the
plug
of
the
power source cord.
• For cleaning the
lens
surfaces, füst
remove
dust,
using
a sott
haJr
brush, or
wipe
it
off lightly,
using
a gauze.
• Only
for
removing
finger
marks or grease,
use
a soft,
clean
cotton cloth, specified
lens
tissue
or
gauze, soaked with a bit of absolute alcohol (ethanol
or
methanol).
e For cleaning the parts painted or
made
of
plastic,
avoid
the
use
of such organic solvents
as
alcohol, ether, thinner, etc.
e
Do
not
use
other tools other than the specified, except
for
an
unavoidable
case.
• Apply only specified
oils
to
the parts, r"ferring
to
the
lubricant table, to keep
up
the
efficiency
of
the instrument.
-1-