Filter
Top Products
Problem solving guide
31
Problem Cause and remedy
The Start indicator light
flashes slowly and the
display is dark.
The dryer is in standby mode. This is a normal
function and does not indicate a fault.
See "Standby" in "Settings".
The Clean out airways
indicator light comes on
at the end of a
programme.
There is a build-up of fluff in the airways.
Clean the fine filter.
Clean the fluff filters
Open and close the door while the dryer is
switched on. The indicator light will go out.
The programme is
cancelled and the Clean
out airways indicator
light comes on.
An excessive amount of fluff has built up.
Clean the fine filter, fluff filter and heat exchanger.
Open and close the door while the dryer is
switched on. The indicator light will go out.
Bars flash in the display
at the end of a
programme:
.........
The programme has finished but the laundry has not
yet cooled down.
Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.
appears in the
display
The programme selector has been moved.
Select the original programme. The time remaining
will appear in the display again.