Filter
Top Products
Operating the tumble dryer
15
Display h min
The display shows:
– the programme duration (h min =
hours and minutes)
– Check and fault messages
– Settings
The settings are used to tailor the
dryer's electronics to suit your
individual requirements.
See "Settings" for more information.
Estimated time remaining
After the start of a programme the
estimated programme duration will
appear in the h min display in hours
and minutes (estimated time remaining).
The only exception to this are the
Timed drying programmes which last
for 20 minutes.
The estimated duration (time remaining)
will appear in the display. The following
factors all affect the estimated time
remaining: residual moisture content
after spinning; type of fabric; size of
load; room temperature; fluctuations in
power supply. The electronics
continually assess conditions in the
appliance and adjust the estimated
time remaining for a more accurate
reading. Because of this, the time
displayed can alter during the course of
a programme. Programmes can also
finish earlier than expected, if, for
example, particularly fine fabric is being
dried, the load is very small or items
were partially dry beforehand.
Drum lighting
If the dryer is switched on at the mains
and the door is opened, the drum
lighting will come on. It will go out a few
minutes later to save energy.
Before using for the first time
Ensure that the dryer is installed
and connected to the electricity
supply correctly. If the tumble dryer
has not been transported as
described in "Installation and
connection" then it must be left to
stand for at least 1 hour before it is
connected to the electricity supply.