Filter
Top Products
18
4. Remove screws from each side of the vent. Attach the left and
right side overcounter support brackets to the downdraft vent
and push up to align the screw holes. Use screws to secure
the brackets.
5. Attach the left and right side end caps to the downdraft vent.
Place the end cap upon the overcounter support, slide the tab
into the slot and snap into place over the plastic tabs.
6. Attach support legs to side of downdraft vent with 2 screws in
each leg. Do not tighten screws.
7. Using 2 or more people, insert the downdraft vent into the
countertop cutout. Check that downdraft vent is parallel to
side of cutout and that mounting brackets overlap countertop.
8. Move support legs down against cabinet floor. Place a level
against the front of the downdraft vent base and adjust until
downdraft vent is level vertically. Use a pencil to mark the top
of each leg on the downdraft vent and the location of the
support leg mounting holes on the cabinet floor.
9. Remove downdraft vent from cutout. Drill starter holes at each
mounting screw location on the cabinet floor. Align the top of
the legs with pencil marks on the face of the downdraft vent.
Tighten screws in legs.
Determine which venting direction is best for your
installation.
When installed in a cabinet, vent system can exhaust through the
front or rear of the vent box.
Front venting:
Downdraft vent is shipped with a vent collar in the front
position so no modification is required. See “Complete
Installation” section.
Rear venting:
NOTE: The blank panel and 10" (25.4 cm) diameter vent collar
need to be removed and placed in the opposite position.
1. To remove panels, loosen the 2 hex/slotted head screws that
attach the top bracket that secures the motor to the vent box
enough to slide the bracket into the “Z” slots. This will move
the bracket away from the top mounting lip of the blower box
and allow it to tilt away from the vent box panel.
A. Overcounter support bracket
B. 10" round vent mounting collar plate
C. Overcounter support bracket screw
A. End cap
A. Blower motor box
B. Support leg
A
B
C
A
A
B
A.Level
B.Mark locations.
A. Bracket with “Z” slots
B. Hex/slotted head screws (2)
B
A
B
A
B