Filter
Top Products
13
Rear Mounting - Blower Motor
NOTE: Optional blower motor mounting position (opposite side).
The blower motor box assembly can also be moved to the
opposite side (rear) of the vent box.
1. Loosen the 2 hex/slotted head screws that attach the top
bracket that secures the motor to the vent box enough to slide
the bracket into the “Z” slots. This will move the bracket away
from the top mounting lip of the blower box and allow it to tilt
away from the vent box panel.
2. Lift up the blower box from the bottom mounting channel.
3. Disconnect the wire connector from the blower motor.
4. Remove panel from the opposite side of blower motor. Loosen
the 2 hex/slotted head screws that attach the top bracket that
secures the panel to the vent box enough to slide the bracket
into the “Z” slots. This will move the bracket away from the
top mounting lip of the panel and allow it to tilt away from the
vent box panel.
5. Lift up the panel from the bottom mounting channel.
A.Panel
B. Blower motor - rear mounting
A. Bracket with “Z” slots
B. Hex/slotted head screws (2)
A.Blower box
B. Bottom mounting channel
A
B
B
A
B
A
B
A. Blower motor
B. Wire connector
A. Bracket with “Z” slots
B. Hex/slotted head screws (2)
A. Blower mounting channel
B. Panel
A
B
B
A
B
A
B