Filter
Top Products
12
7. Plug in the wire connector to the blower motor.
8. Place the vent extension for the 6" (15.2 cm) diameter venting
over the vent exhaust and screw into place using the 4
screws.
9. Replace the vent box over the blower motor.
10. Place the bottom tab of the blower box into the bottom
mounting channel.
11. Tilt blower box top tab so it is flush with the vent box panel
and position it under the top mounting bracket.
12. Slide bracket into the “Z” slots.
13. Tighten the 2 hex/slotted head screws to secure.
14. Place the small vent cover over the hole in the vent box and
secure in place with the 4 screws.
15. See “Complete Installation - Interior Mounted Motor” section.
A. Blower motor
B. Wire connector
A. Vent extension screws (4)
A. Blower motor
B. Vent box
A
B
A
A
A
B
A.Blower box
B. Bottom mounting channel
A
B