Filter
Top Products
3-1-2. .Rear panel
~.,CD
@
@
~
@ VOX GAIN control
This control adjusts the sensitivity of the VOX ampli-
fier. Adjust this control for your personal preference.
CD ACC 3 terminal
Spare RCA type terminal. No internal connections have
been made.
@ AFSK IN terminal
AFSK input terminal.
VOX GAIN
(6)'\
@ AFSK OUT terminal
Constant level AF output terminal for AFSK operation,
CD ACC 1 jack
This jack is designed for connection of the 6-pin DIN
connector supplied with the optional interface unit.
@ ANTI VOX control
vox operations are sometimes difficult with high
speaker volume control settings. The ANTI VOX con-
trol is used to reduce the tendency of the VOX to acti-
vate from inputs from the speaker. The ANTI VOX
control is not active when headphones are connect-
ed, for obvious reasons!
@ EXT. SP (External speaker) jack
This jack is for connection of an external speaker.
@ DC power connector
This is used to connect the DC power supply.
@ KEY jack
Using shielded line, connect a 1/4" phone plug to this
jack for CW operation. Open-terminal voltage is approx-
imately 5.5 VDC.
@ DELAY control
This control adjusts the "hang-time" that the radio will
remain keyed after voice input has stopped.
DELAY
{(§)\
([j) ANT (Antenna) connector
This UHF connector should be attached to a suitable
anten~a for transmitting and receiving. The antenna ca-
ble should be 50-ohm coax, terminated with a PL-259
connector.
@ GND (Ground) terminal
To prevent electric shock, as well as RFI and BCI, con-
nect the transceiver to a good earth ground.
10