Filter
Top Products
4. Cut the lead of diode 065 located below the dip
switch on the control unit.
5. Reverse steps 1.-3. to reassemble the radio.
Notes:
1. When reassembling the radio make sure that
you do not cut or pinch any wires between the
chassis and front panel!
2. Do not alter the settings of the dip switch. They
are factory adjusted, and damage or misoper-
ation may result.
5-8-6. Side tone level
1. Remove the top cover.
2. Adjust VR-9 for your reference
3. Replace the top cover.
'"
~~
CO"t,~
5-8-8. Beep tone level
1 .Remove the top cover.
2. Adjust VR-l0 for your reference.
3. Replace the top cover.
5-8-7. Beep tone selection
The audio oscillator that provides the Morse Code sig-
nal when you press a mode key may be changed to
provide only a single confirmation tone by cutting di-
ode 065 on the Control unit.
1. Remove the top and bottom covers from the radio.
2. Remove the countersink screws (2 on each side)
that secure the front panel to the chassis and gently
pull the front panel forwards.
3. Remove the 5 small round head screws that secure
the shield plate (2 on the top and 3 on the bottom)
to the front panel, and remove the shield plate.
25