Support User Manuals

Invacare X-Terminator Titanium Wheelchair User Manual

Open as PDF

of 76

SECTION 7—FOOTREST/ ANTI-TIPPER

Everyday and Sport Series Wheelchairs 64 Part No 1114851

FIGURE 7.3 Replacing/Adjusting Optional A4 Footrest

Adjusting Footplate Angle

1. Loosen,butDONOTremovethefourflatscrewsandlocknutsthatsecurethe

footplatetothetwofootresttubes.

2. Positionthefootplatetothenecessaryangletoaccommodatetheuser.

3. Retightenthefourflatscrewsandlocknuts.

NOTE:Thelocknutsshouldlieinthechannelofthefootplatehalfclamp.

Adjusting Footplate Depth

1. Loosen,butDONOTremovethefourflatscrewsandlocknutsthatsecurefootplate

tothefootresttubes.

NOTE:Observetheangleoffootplateforreinstallation.

2. Movethefootplatetooneoftwopositionstoaccommodatetheuser.

3. Retightenthefourflatscrewsandlocknuts.

NOTE:Thesettingsforpositioningthefootplateson

thehalf‐clampsmayvaryforeachenduser.

NOTE:Thelocknutsshouldlieinthechannelofthefootplatehalfclamp.

Installing the X-Terminator Footrest

NOTE:Forthisprocedure,refertoFIGURE 7.4.

1. Installthetwohalfclampsontoeithersideofthewheelchairframeapproximately2

inchesabovetheexistingfootrestwithtwoprovidedallenscrews.

2. Repeatfortheoppositesideofthewheelchair.

3. Slidetheclamponraisedfootrestintothehalfclampstothedesired

height.

4. Securelytightenthefourallenscrews.

Allen Screws

Footrest

Tube

Flat

Screws

Footplate

Flat Screws

Angle

Depth

Height

previous next