Support User Manuals

Invacare X-Terminator Titanium Wheelchair User Manual

Open as PDF

of 76

SECTION 5—WHEELS

Part No 1114851 41 Everyday and Sport Series Wheelchairs

Adjusting Rear Wheel Camber

NOTE:Forthisprocedure,refertoFIGURE 5.7.

Camber Tube 2000

Theaxletubemustbereplacedtochangethecamber.RefertoReplacingAxleTubeon

page 49.

A4 Camber System

NOTE:Performthisproceduretoonesideof

thewheelchairatatimeforeaseofadjustment.

1. Openthecamberclamp.Referto

Opening/ClosingCamberClampson

page 39.

2. Pullonerearwheelwithcamberinsert

outofaxletube.

3. Removetherearwheelfromthe

camberinsert.

4. Rotatethecamberinsert180°.

5. Reinstalltherearwheelintothecamber

insert.

FIGURE 5.7 Adjusting Rear Wheel Camber

- A4 Camber System

ƽ WARNING

NEVER position the camber inserts in the axle tube with more than 3-inches (12

indexing marks showing) of the camber insert outside of the axle tube. The camber

inserts will not be securely tightened in the axle tube. Possible injury to the user

and/or damage to the wheelchair may occur.

6. Positionthecamberinserttothedesiredposition.Makesurethereisnomorethan

3inches(12indexingmarks)ofthecamberinsertsoutsideoftheaxletube.

7. Slidetheindexingringonthecamberinsertuntilitisflushwiththecamberclamp.

NOTE:Beforeusingthewheelchair,makesurebothcamberinsertsaresettothesameindexing

mark.Thiswillmakesurethedistancebetweentherearwheelandthewheelchairisthesameon

bothsides.

ƽ WARNING

QUICK RELEASE LEVERS - Make sure the quick release levers are pointing

towards the rear of the wheelchair and are in the closed position before using the

wheelchair, otherwise personal injury or damage to the wheelchair may occur.

Rear View of Wheelchair

Camber

Clamp

Axle

Tube

Camber Insert -

Rotate 180°

Indexing Ring

Indexing Marks

previous next