Support User Manuals

Invacare X-Terminator Titanium Wheelchair User Manual

Open as PDF

of 76

SECTION 5—WHEELS

Part No 1114851 39 Everyday and Sport Series Wheelchairs

NOTE:Ifreplacingrearwheels withadifferentsizethanwhatwasoriginallyonthewheelchair,

thefrontcasterheightmustalsobechangedtokeepthewheelchairframeparalleltothefloor.Refer

toAdjustingFrontCasterHeightonpage 55ONLYaftercontactingInvacare.Anti‐tipperheight

(ifapplicable)mustalsobeadjustedtomaintain1‐1/2to2‐inchclearancebetweenbottomofthe

anti‐tipperwheelsandthefloor.RefertoAdjusting/ReplacingAnti‐tipperonpage 66.

Opening/Closing Camber Clamps

ƽ WARNING

QUICK RELEASE LEVERS - Make sure the quick release levers are in the closed

position before using the wheelchair, otherwise personal injury or damage to the

wheelchair may occur.

STANDARD AND SUSPENSION CAMBER CLAMPS - Make sure the hex screws

are securely tightened before using the wheelchair, otherwise personal injury or

damage to the wheelchair may occur.

CAUTION

A4 CAMBER SYSTEM ONLY - DO NOT close the quick-release levers or tighten

the socket screws or hex screws without camber inserts in the axle tube. Damage to

the axle tube will occur.

NOTE:Forthisprocedure,refertoFIGURE 5.6.

1. Performoneofthefollowingtoopenacamberclamp:

•QuickReleaseLevers‐Pullthequickreleaselevertotheopenposition.

• StandardCamberClamps‐Loosen,butDONOTremovethesocketscrewonthe

camberclamp.

•SuspensionCamberClamps‐Loosen,butDONOTremovethehexscrewonthe

bottomrearofthecamberclamp.

2. Performoneofthefollowingtocloseacamberclamp:

•QuickReleaseLevers‐Securethequickreleaselevertothecamberclampby

threadingitcompletelyintothecamberclamp.Pushthequickreleaseleveronthe

camberclampstothe

closedposition.

• StandardCamberClamps‐Securelytightenthesocketscrewtosecuretheaxle

tube.

•SuspensionCamberClamp‐Securelytightenthehexscrewonthebottomrearof

thecamberclamptosecuretheaxletube.

previous next