Support User Manuals

Invacare X-Terminator Titanium Wheelchair User Manual

Open as PDF

of 76

SECTION 5—WHEELS

Everyday and Sport Series Wheelchairs 48 Part No 1114851

Adjusting Wheelbase Width

NOTE:Performthisprocedureononesideofthewheelchairatatimeforeaseofadjustment.

Camber Tube 2000

NOTE:Forthisprocedure,refertoFIGURE 5.13.

NOTE:Thewheelbasewidthcanbeincreased/decreasedby1‐inch.

1. Removetherearwheels.RefertoRemoving/InstallingRearWheels

onpage 35.

2. Torquetheaxlenutto

increase/decreasethewheelbasewidth.

3. Countthenumberofthreadsshowing

ontheaxlebolt.

NOTE:Thenumberofthreadsshowingonthe

axleboltshouldbeequalonbothsidesofthe

wheelchair.Otherwise,wheelchair performance

maybeaffected.

4. RepeatSTEPS2‐3forthe

oppositeaxle

nutandaxlebolt.

NOTE:Axleboltremovedfromaxletubefor

clarity.Itisnotnecessarytoremovetheaxle

boltforthisprocedure.

FIGURE 5.13 Adjusting Wheelbase Width

- Camber Tube 2000

A4 Camber System

NOTE:Forthisprocedure,refertoFIGURE 5.14.

1. Openthecamberclamp.RefertoOpening/ClosingCamberClamps

onpage 39.

ƽ WARNING

NEVER position the camber inserts in the axle tube with more than 3 inches (12

indexing marks showing) of the camber insert outside of the axle tube. The camber

inserts will not be securely tightened in the axle tube. Possible injury to the user or

damage to the wheelchair may occur.

2. Positioncamberinserttothedesiredposition.Makesuretherearenomorethan3

inches(12indexingmarksshowing)ofthecamberinsertsoutsideoftheaxletube.

3. Slidetheindexingringonthecamberinsertuntilitisflushwiththecamberclamp.

NOTE:Beforeusingthewheelchair,make

surebothcamberinsertsaresetatthesameindexing

mark.Thiswillmakesurethedistancebetweentherearwheelandthewheelchairisthesameon

bothsides.

Axle

Tube

Axle Nut

Camber

Clamp

Axle Bolt

Threads

Camber

Insert

previous next