Filter
Top Products
SECTION 5—ARMS
Part No 1122134 45 Compass™SPT™
Adjusting T-Arm Sockets
NOTE: For this procedure, refer to FIGURE 5.7.
NOTE: Perform this procedure if the T-Arm is too loose in the socket or does not easily slide UP
and DOWN in the socket.
1. Remove the rear wheels from the wheelchair, if necessary. Refer to
Installing/Removing Rear Wheels on page 58.
2. Loosen, but DO NOT remove the four hex screws and washers that secure T-Arm
socket to T-Arm clamp.
NOTE: The T-Arm socket will disassemble if the four hex screws and washers are removed.
3. Slide the T-Arm into the T-Arm socket until the locking lever is in the slot in the T-Arm
socket and an audible “click” is heard.
4. Squeeze the T-Arm socket and the T-Arm clamp together until the socket is flush with
the T-Arm.
5. While holding the T-Arm socket and the T-Arm clamp together, tighten the four hex
screws and washers. Tighten securely.
6. Press IN on the locking lever and lift the T-Arm straight UP and out of the T-Arm
socket.
7. Repeat STEPS 3-6, if necessary until the T-Arm slides in the T-Arm socket as desired.
8. If necessary, install rear wheels. Refer to Installing/Removing Rear Wheels on page 58.
FIGURE 5.7 Adjusting T-Arm Sockets
Hex Screws
and Washers
T-Arm
Hex Screws and
Washers
T-Arm Socket
T-Arm Clamp
Locking Lever
Slot