Filter
Top Products
SECTION 9—WHEEL LOCKS AND ANTI-TIPPERS
Compass™SPT™ 62 Part No 1122134
Installing/Adjusting Anti-Tippers
NOTE: For this procedure, refer to FIGURE 9.2.
NOTE: A 1½ to 2-inch clearance between the bottom of the anti-tipper wheels and the floor MUST
be maintained at all times.
Installing Anti-Tippers
1. Remove the anti-tippers from the accessory carton.
ƽ WARNING
Anti-tippers MUST be fully engaged and spring buttons fully protruding out of
adjustment holes.
2. Press the release button in and insert the anti-tippers into the anti-tipper mounting
bracket on the wheelchair frame until the spring button protrudes from the top
adjustment hole.
3. Ensure the anti-tipper wheels are 1½ to 2-inches from the ground/floor.
4. Adjust the anti-tipper if necessary. Refer to Adjusting Anti-Tippers on page 62.
Adjusting Anti-Tippers
NOTE: A 1½ to 2-inch clearance between the bottom of the anti-tipper wheels and the floor MUST
be maintained at all times.
1. Press the release button in and adjust the anti-tipper until the spring button protrudes
from the other adjustment hole in the anti-tipper mounting bracket.
FIGURE 9.2 Installing/Adjusting Anti-Tippers
Anti-Tipper
Release Button
Adjustment
Hole
Mounting
Bracket
Wheelchair
Frame
Spring Button