Filter
Top Products
SECTION 5—ARMS
Part No 1122134 41 Compass™SPT™
3. Lock the armrest assembly by pressing the release lever into the down (vertical)
position as shown in Detail “A”.
4. Pull up on the armrest assembly to ensure the armrest is locked in place.
5. Repeat STEPS 1-4 for opposite side of wheelchair, if necessary.
FIGURE 5.1 Using/Adjusting Dual Point Arms
Replacing Dual Point Arm Pad
NOTE: For this procedure, refer to FIGURE 5.2 on page 41.
1. Remove the mounting screws that
secure the arm pad to the armrest
assembly.
2. Replace arm pad and securely tighten
with the existing mounting screws.
Replacing Dual Point Arm
Clothing Guards
NOTE: For this procedure, refer to
FIGURE 5.2 on page 41.
NOTE: This procedure is for fixed height dual
point arms ONLY.
1. Remove the four screws that secure the
existing clothing guard to the armrest
assembly.
FIGURE 5.2 Replacing Dual Point Arm
Pad/Replacing Dual Point Arm Clothing
Guards
Dual Point Arm
Height
Adjustment
Lever
Rear Arm
Socket
Front Socket
Arm
Arm Release
Lever
Locked - Down
(Vertical)
Unlocked - Up
(Horizontal)
DETAIL “A”
Mounting
Screws
Armrest
Assembly
Screws
Screws
Clothing
Guard
Arm Pad