Support User Manuals

Invacare Nutron Series Mobility Aid User Manual

Open as PDF

of 72

SECTION 7—ARMS

Nutron® Series 38 Part No.1106644

Using Swing-Back Arms

ƽ WARNING

Make sure the armrest release lever is in the locked position before using the wheel-

chair.

NOTE:Forthisprocedure,refertoFIGURE 7.2.

1. Unlocktheswing‐backarmsbyrotatingthearmrestreleaselevertowardtheoutside

ofthewheelchair.

2. Pullthefrontoftheswing‐backarm

straightup/outofthearmsocketand

towardtherearofthewheelchair.

3. Tousetheswing‐backarm,push

the

swing‐backarmtowardthefrontofthe

wheelchairandthendownwardinto

thearmsocket.

NOTE:ArmrestreleaseleverMUSTbeinthe

unlockedpositionwhenplacingarmrestinto

thearmsockets.

4. Locktheswing‐backarmsbyrotating

thearmrestreleaselevertowardthe

insideofthewheelchair.

FIGURE 7.2 Using Swing-Back Arms

Replacing Desk/Full Length Armrest Pad and/or

Clothing Guards (Fixed Height Arms Only)

NOTE:Forthisprocedure,refertoFIGURE 7.3.

Armrest Pad

1. Removethetwo(2)mountingscrewsthatsecurethearmrestpadtothearmrest

assembly.

2. Replacearmrestpadandsecurelytightenwiththeexistingmountingscrews.

3. RepeatSTEPS1and2fortheotherarmrest.

Clothing Guard

1. Removethefour(4)mountingscrewsthatsecuretheexistingclothingguardtothe

armrestassembly.

2. Installnewclothingguardandsecurelytightenwiththeexistingmountingscrews.

3. RepeatSTEPS1and2fortheotherclothingguard.

Swing Back Arm

(Front)

Armrest

Release

Lever

Arm

Socket

Wheelchair

(Rear)

previous next