Support User Manuals

Invacare Nutron Series Mobility Aid User Manual

Open as PDF

of 72

SECTION 6—FRONT RIGGINGS

Part No.1106644 33 Nutron® Series

Model 93M, 904A, PAL4A, and PAS4A Footrests

NOTE:Forthisprocedure,refertoFIGURE 6.3.

1. Loosen,butdonotremovethelugboltandlocknutthatsecurethelowerfootrestto

thefootrestsupport.

2. Repositionthelowerfootresttothedesiredheight.

3. Securelytightenthelugboltandlocknutthatsecurethelowerfootresttothefootrest

support.

4. RepeatSTEPS1‐3fortheotherfootrest,ifnecessary.

FIGURE 6.3 Adjusting the Footrest Height - Model 93M, 904A, PAL4A, and PAS4A Footrests

Replacing Heel Loops

NOTE:Forthisprocedure,refertoFIGURE 6.4.

1. Notethepositionofhexbolt,coved

washersandlocknutforreinstallation.

2. Removethehexbolt,covedwashers

andlocknutthatsecurethelower

footresttothefootrestsupport.

3. Removethelowerfootrest.

4. Removethephillipsbolt,spacerand

locknutthatsecuretheexistingheel

loop

tothelowerfootrest.

5. Slidetheexistingheelloopoffthe

lowerfootrest.

6. Replaceheelloop.

7. ReverseSTEPS1‐6toreassemble.

NOTE:Whensecuringheellooptolower

footrest,tightenthephillipsscr ewandlocknut

untilthespacerissecure.

FIGURE 6.4 Replacing Heel Loops

NOTE:93Mstylefootrestshown.904A,PA L 4 A andPAS 4 A footrestsadjustthesameway.

Lower Footrest

Footrest Support

Lug Bolt

Locknut

Footrest Support

Hex Bolt

Phillips Bolt

Spacer

Locknut

Locknut

Coved

Washers

Lower Footrest

Heel Loop

previous next