Invacare Back Support Mobility Aid User Manual


 
3
SAFETY SUMMARY
SAFETY SUMMARY
S
A
F
E
T
Y
S
U
M
M
A
R
Y
NOTE: Check all parts for shipping damage. In case of damage, DO NOT use. Contact your Dealer for further instruction.
INSTALLATION WARNINGS
Stabilize from the ground up. A stable base, pelvis and footrests are requirements for any
torso positioning system.
For proper installation of the Infinity Back and to reduce the risk of pressure sores, the
adjustment procedures in this manual MUST be performed in the following order:
1. Adjusting the Mounting Hardware
2. Adjusting the Hinge/Angle (DUALFLEX ONLY)
3. Adjusting the Depth Hardware
4. Adjusting the Lateral Supports
Ensure the Infinity Back is properly secured to the wheelchair BEFORE using. Upper
mounting pins must sit flush in the upper (swivel) cane clamps for the clamp lock to secure
the Infinity Back to the wheelchair. Lower mounting pins must rest in the groove on the
flange of the lower (fixed) cane clamps. Otherwise changes in seat depth will occur,
making the wheelchair less stable.
After ANY adjustments, repair or service and BEFORE use, make sure all attaching hard-
ware is tightened securely - otherwise injury or damage may occur.
STABILITY WARNINGS
The seat height, seat depth, back height, tilt angle, back angle, pivot point of seat frame,
seating system, caster position, size and position of the rear wheels, wheel locks, anti-tippers,
locking collar as well as the user condition directly relate to the stability of the wheelchair.
Any change to one (1) or any combination of the fourteen (14) may cause the wheelchair to
decrease in stability. Use EXTREME caution when using a new seating position.
Seat Height
Back Height
Seat Depth
Back Angle
Seating System
Tilt Angle
Seat Frame Pivot Point
Caster Position
Rear Wheel Size
Rear Wheel Position
User Condition
Seat Dump
Locking Collar
Seat Height
Back Height
Seat Depth
Back Angle
Seating System
Tilt Angle
Seat Frame Pivot Point
Caster Position
Rear Wheel Size
Rear Wheel Position
User Condition
Wheel Locks
Anti-Tipppers
Locking Collar
Seat Dump
NOTE: When changes to the left hand column occur, follow across the chart and refer to the
procedure
to maintain the proper stability, safety and handling of the wheelchair.
NOTE: Additional adjustments may be needed according to the wheelchair type. Refer to the wheelchair
owner's manual for these procedures.