Invacare 440 Blood Pressure Monitor User Manual


 
SECTION 3—OPERATION
Part No 1141431 19 Reliant 440
FIGURE 3.6 Mounting the Battery Charger
Charging the Battery
NOTE: For this procedure, refer to FIGURE 3.7 on page 20.
NOTE: Invacare recommends the battery be recharged daily to prolong battery life.
NOTE: An audible alarm will sound (horn will beep) when battery is low.
1. Lift up on the handle on the back of the battery (Detail “A”).
2. Lift the battery up and out from the control box.
ƽ WARNING
Make sure there is an audible click when mounting battery either on the battery
charger or the control box to confirm proper mounting. Otherwise, injury or dam-
age may occur.
3. Place the battery on the battery charger (Detail “B”).
4. Ensure there is an audible click (Detail “C”).
NOTE: The charge LED will illuminate. When charging is complete, the charge LED will stop
illuminating.
NOTE: A battery needing to be fully recharged will take approximately four hours.
5. Lift up on the handle on the back of the battery (Detail “A”).
6. Lift the battery up and out away from the battery charger.
7. Reinstall the battery onto the control box (Detail “B”).
8. Ensure there is an audible click (Detail “C”).
Mounting Bracket (STEP 6)
Mounting
Screws
(STEP 7)
Battery Charger
with Mounting
Bracket (STEP 5)
BOTTOM Mounting
Screw (STEP 4)