Filter
Top Products
SECTION 1—GENERAL GUIDELINES
Reliant 440 12 Part No 1141431
DO NOT alter slings.
ALWAYS keep hands and fingers clear of moving parts to avoid injury.
When elevated a few inches off the surface being transferred from and before moving the
patient, check again to make sure that the sling is properly connected to the attachment
points of the stand-up lift. If any attachments are NOT properly in place, lower the patient
back onto the surface and correct this problem.
During transfer, with patient suspended in a sling attached to the lift, DO NOT roll stand-
up lift over objects such as carpet, raised carpet bindings, door frames, or any uneven
surfaces or obstacles that would create an imbalance of the stand-up lift and could cause
the stand-up lift to tip over.
Use push handle on the mast at ALL times to push or pull the stand-up lift.
Casters and axle bolts require inspection every six months to check for tightness and wear.
Grounding Instructions
DO NOT, under any circumstances, cut or remove the round grounding prong from any
plug used with or for Invacare products. Some devices are equipped with three-prong
(grounding) plugs for protection against possible shock hazards. Where a two-prong wall
receptacle is encountered, it is the personal responsibility and obligation of the customer
to contact a qualified electrician and have the two-prong receptacle replaced with a
properly grounded three-prong wall receptacle in accordance with the National Electrical
Code. If you must use an extension cord, use only a three-wire extension cord having the
same or higher electrical rating as the device being connected. In addition, Invacare has
placed RED/ORANGE warning tags on some equipment. DO NOT remove these tags.
Carefully read battery/battery charger information prior to operating, charging or
servicing your stand-up lift.
Weight Limitation
DO NOT exceed maximum weight limitation of the stand-up lift. The maximum weight
limitation is 440 lbs regardless of any additional weight limitations on accessories.