Filter
Top Products
SECTION 3—OPERATION
Reliant 440 18 Part No 1141431
FIGURE 3.5 Emergency Lowering
Mounting the Battery Charger
NOTE: For this procedure, refer to FIGURE 3.6.
NOTE: Refer to your local regulations concerning proper mounting procedures.
1. Place the battery charger with mounting bracket on the wall at the desired position.
2. With a pencil, mark the middle hole position.
3. Measure down 6½ inches from the pencil mark and drill one mounting hole.
4. Install the bottom mounting screw until there is an approximate 1/8-inch gap between
the screw head and the wall.
5. Install the battery charger with mounting bracket onto the bottom mounting screw.
6. Drill the remaining two mounting holes.
7. Install the two remaining mounting screws through the mounting bracket and into the
wall. Tighten securely.
8. Plug the battery charger into the wall electrical outlet.
NOTE: The On LED should illuminate.
Press Ballpoint Pen
Tip Here for
Emergency Lowering
DETAIL “A”
DETAIL “B”
Pull Up Red
Tag for
Emergency
Lowering
RED Emergency
Stop Button
Control
Box
Actuator
Column