Filter
Top Products
SECTION 2—ASSEMBLY
Reliant 440 14 Part No 1141431
FIGURE 2.1 Assembling the Patient Lift
Attaching Kneepad
ƽ WARNING
The kneepad is an integral part of the lift and MUST be attached so that the lift can
funwction correctly and safely.
CAUTION
When connecting the actuator to the boom, DO NOT over-tighten the bolt
because this will deform the clevis and restrict the pivot.
NOTE: For this procedure, refer to FIGURE 2.2 on page 15.
1. Connect the top of the actuator to the boom using the bolt provided (Detail “A”).
2. Insert the two posts of the kneepad into the tube retainers of the kneepad receiver
while turning the kneepad release lever in a clockwise direction (Detail “B”).
3. Release the kneepad release lever.
Mounting
Screws
DETAIL “A”
DETAIL “B”
Rod
Ends
Base
Base
Mast
Mast
Mounting
Screws
DETAIL “C”
Cable Tie
Actuator
Boom
DETAIL “D”
Mounting
Screws
Washers
Locknuts
Mast
Push Handle
Tab
Locknut
Washer
Washer
Locknut