Support User Manuals

Invacare 1114851 Wheelchair User Manual

Open as PDF

of 76

SECTION 7—FOOTREST/ ANTI-TIPPER

Part No 1114851 65 Everyday and Sport Series Wheelchairs

Adjusting the X-terminator and Transformer Footrests

NOTE:Forthisprocedure,refertoFIGURE 7.4andFIGURE 7.5.

Depth

1. Removethefourallenscrewsfromthefootrestandblocks.

2. Movefootrestrearwardorforwardtodesireddepth.

3. Aligntheholesinthefootrestwiththeholesintheblocksonfootresttubing.

4. Installallenscrewsintofootrestandintotheblocks.

5. Securelytightenthefourallenscrews.

Angle

1. Loosenthebuttonscrewsontheblocks

onbottomofthefootresttubing.

2. Adjusttheangleofthefootrest.

3. Retightenthebuttonscrewssecurely.

X-Terminator Height

1. Loosenthefourallenscrews.

2. Adjustclamponraisedfootresttothe

desiredheight.

3. Securelytightenthefourallenscrews.

FIGURE 7.4 Installing the X-Terminator

Footrest - Adjusting the X-terminator and

Transformer Footrests

Transformer Height

NOTE:Forthisprocedure,refertoFIGURE 7.5.

1. Notetheorderofthemountingscrew,covedwashers,spacer,halfclampsand

mountingscrew/threadedsleeveandtheirpositiononthewheelchairframeand

footresttubing.

2. Removethemountingscrew,covedwashers,spacer,halfclampsandmounting

screw/threadedsleeveonbothsidesofthewheelchair.

3. Chooseanadjustmentholeonthefootresttubingthatwillraiseorlowerthefootrest

tothedesiredposition.

4. Reinstallthemountingscrew,covedwashers,spacer,halfclampsandmounting

screw/threadedsleeveonbothsidesofthewheelchair.

5. Securelytighten.

Allen Screws

Button Screws

Blocks

Depth

Adjustment

Holes

Footrest

Footrest

Tubing

Allen

Screws

Half Clamps

previous next