Support User Manuals

Invacare 1114851 Wheelchair User Manual

Open as PDF

of 76

SECTION 5—WHEELS

Everyday and Sport Series Wheelchairs 52 Part No 1114851

Camber Tube 2000

NOTE:Forthisprocedure,refertoFIGURE 5.16.

1. Ifnecessary,openbothcamberclamps.RefertoOpening/ClosingCamberClampson

page 39.

2. UsinganʺLʺsquare,rotatetheaxle

tubeuntiltheflatedgeofthecamber

tubeisata90°anglewiththe

ground/floorasshowninFIGURE 5.16.

3. Closebothcamberclamps.Referto

RefertoOpening/ClosingCamber

Clampsonpage 39.

4. Determinethetoein/toeoutofthe

wheelchair.RefertoDeterminingToe

In/ToeOutonpage 42.

FIGURE 5.16 Adjusting the Axle Tube -

Camber Tube 2000

A4 Camber System

NOTE:Forthisprocedure,refertoFIGURE 5.17.

NOTE:Beforeperformingthisprocedure,makesur ethecamberinsertsarepositionedtothelowest

degreeofcamber.RefertoAdjustingRearWheelCamberonpage 41.

1. Ifnecessary,openbothcamberclamps.RefertoOpening/ClosingCamberClampson

page 39.

2. Loosenthesetscrewthatsecureseachtoeadjustmentringtotheaxletube

(FIGURE 5.17).

3. UsinganʺLʺsquare,rotatetheaxletubeuntiltheflatedgeofthecamberinsertisata

90°anglewiththeground/floorasshowninFIGURE 5.17.

4. Closetherightcamberclamp.Referto

Opening/ClosingCamberClampsonpage 39.

5. RotatetheLefttoeadjustmentringuntilthetabstopsagainsttheLowermetaltabon

thecamberclamp.

6. Securelytightensetscrewonlefttoeadjustmentring.

7. Measurethedistancebetweenthecenterlinesattherearandfrontoftherearwheels

atapproximately12inchesfromtheground/floor.RefertoDeterminingToeIn/Toe

Outonpage 42.

8. Performoneofthefollowing:

•ToeIn/ToeOutMeasurementisWithin±1/8‐inch‐ProceedtoSTEP9.

•ToeIn/ToeOutMeasurementisNotWithin±1/8‐inch‐RepeatSTEPS1‐7untiltoe

in/toeoutmeasurementiswithin±1/8inch.

9. Opentherightcamberclamp.RefertoOpening/ClosingCamberClampsonpage 39.

Ground/

Floor

90° Angle

Place “L” Square Here

Flat Edge of

Camber Tube

previous next