Support User Manuals

Invacare 1114851 Wheelchair User Manual

Open as PDF

of 76

SECTION 5—WHEELS

Part No 1114851 49 Everyday and Sport Series Wheelchairs

ƽ WARNING

QUICK RELEASE LEVERS - Make sure the quick release levers are pointing

towards the rear of the wheelchair and are in the closed position before using the

wheelchair, otherwise personal injury or damage to the wheelchair may occur.

STANDARD AND SUSPENSION CAMBER CLAMPS - Make sure the hex screws

are securely tightened before using the wheelchair, otherwise personal injury or

damage to the wheelchair may occur.

4. Closethecamberclamp.RefertoOpening/ClosingCamberClampsonpage 39.

5. RepeatSTEPS1‐4foroppositesideofwheelchair.

FIGURE 5.14 Adjusting Wheelbase Width - A4 Camber System

Replacing Axle Tube

NOTE:Forthisprocedure,refertoFIGURE 5.15.

NOTE:Thecamberbarisalwaysmountedtothebottomofthewheelchairframe.

NOTE:Thereisnoneedtoremovethetwocamberclampswhenreplacingtheaxletube.

1. A4CamberSystemOnly‐Notethepositionofthecamberinsertssotheycanbe

installedatthesamepositioninthenewaxletube.

2. Openthecamberclamps.RefertoOpening/ClosingCamberClamps

onpage 39.

3. Removethetworearwheels.RefertoRemoving/InstallingRearWheels

onpage 35.

4. A4CamberSystemOnly‐Removethecamberinsertspositionedintheaxletube.

5. A4CamberSystemOnly‐Loosen,butDONOTremovethetwophillipsscrewsthat

securethetoeadjustmentringstotheaxletube.

6. Pulltheexistingaxletubethroughoneofthecamberclamps.

7. A4CamberSystemOnly‐Removetoeadjustmentringsfromtheexistingaxletube.

8. Pulltheexistingaxletubethroughtheothercamberclampandremovefromthe

wheelchair.

9. Slidethenewaxletubethroughoneofthecamberclamps.

Axle

Tube

Camber Clamp

Camber Insert

Indexing Marks

Indexing

Ring

previous next