Filter
Top Products
Brookfield Engineering Labs., Inc. Page 47 M/02-212
• Stopbits [Bit]: 1 or 2
Choose the requested parameter from the list of available values and select it by pressing key.
Example Baudrate:
After selecting all parameters, new setting of communication parameters is displayed:
with key you transfer this parameters to nonvolatile memory of R/S Rheometer.
These changed transfer settings will be saved into memory and will remain in the memory also after
switching off the instrument.
VI.7.6 Configuration → Language
This function selects the user-language of R/S Rheometer. Languages available are:
• English
• German
Choose desired language and press .
VI.7.7 Configuration → Service, Service 2
This function is only for service-personnel. Password protected!
VI.8 Serial Data transfer via Interface RS232
Serial data transfer has to be used only in the case, when a user has basics of knowledge on data
processing and is capable to change data transfer parameters of sending and receiving sides, by
him/herself.
Successful data transfer can be achieved only in the case, when a transmitter (=R/S Rheometer) and
the receiver (e.g. a PC) comply to the following:
1. Instruments are connected with supplied interface cable. Caution: While making the connection,
both instruments must be switched off! (Pin layout: see Appendix to this documentation).
2. The transmitter (R/S Rheometer) and the receiver are configurated to identical data transfer
parameters (for R/S Rheometer see Chapter 6.7.5. “Set RS232 Parameter”).
Baudrate:
-4800
_9600
-19200
RS232: 19200,8,n,1
<OK>=storing
OK
OK
OK