Filter
Top Products
World Scale
4-9 Supervisor Mode
Programming a PLU (WC30)
You may program a By Count PLU or a Random Weight PLU.
Refer to the two examples, Programming a By Count PLU (WC30)
and Programming a Random Weight PLU (WC30). When you are
programming a PLU, you must navigate to Function Code 100 plus
the PLU number. For the examples below, we will use PLU 5,
which is Function Code 105. Refer to the Function Codes table for
further information.
If you were programming PLUs 10 through 30, your Function
Codes would be 110, 111, 112, etc. to 130.
Remember that once PLUs 1 through 7 are programmed in
Supervisor mode, they can no longer be programmed as Speedkeys
in Operator mode.
Programming a By Count PLU
(WC30)
1. Enter Supervisor mode according to WC30
instructions. See Entering Supervisor Mode
(WC30).
2. Long PRESS the RIGHT ARROW [
]
key until you get to the Function Code
(Sub-Function zero = Unit Price) for the
PLU you wish to program. In this
example, we will use PLU 5.
3. Short PRESS the [C] key. This tells the
World Scale that you are going to change
the Function Value.
4. Change the Function Value of the Unit Price by
using a Short PRESS on the keypad.
5. Long PRESS the RIGHT ARROW [
] key to get
World Scale to accept the change.
6. Exit Supervisor mode. See Exiting Supervisor Mode (WC30).