Filter
Top Products
World Scale
4-5 Supervisor Mode
Navigating
Supervisor Mode
In Supervisor mode, you navigate by using:
♦ Function Keys
♦ Function Codes
You may also want to review the Examples of Navigating
Supervisor Mode at the end of this chapter.
To navigate Supervisor mode:
1. Enter Supervisor mode according to your scale’s instructions.
See Entering Supervisor Mode (WP30) or Entering Supervisor
Mode (WC30).
2. To get to a Function, Long PRESS the
RIGHT ARROW [
] or LEFT ARROW
[
] keys.
3. To get to a Sub-Function, Short PRESS the
RIGHT ARROW [
] or LEFT ARROW
[
] keys.
4. You will see the Function and Sub-Function
on the Supervisor Display Screen. In this
example, the 19 is the Function and the 00 is
the Sub-Function. The 1 is the current
Function Value.
QUICK STEPS -
Navigating Supervisor Mode
1. Enter per your scale’s method
2. To get to a Function,
Long PRESS [
] or [
]
3. To get to a Sub-Function,
Short PRESS [
] or [
]
4. Function and Sub-Function
display
5. Exit per your scale’s method
5. Exit Supervisor mode according to your scale’s instructions.
See Exiting Supervisor Mode (WP30) or Exiting Supervisor
Mode (WC30).
Function Keys
Function Keys enable you to get from one Function or
Sub-Function to the next.
Use This Key In This Way To Perform This Action
NOTE: After changing a value, you must go to the next Function or Sub-Function so World Scale accepts the change.
Long PRESS
Short PRESS
Go to the next Function.
Go to the next Sub-Function.
Long PRESS
Short PRESS
Go to the previous Function.
Go to the previous Sub-Function.
--OR--
Short PRESS
Long PRESS
Select Function Value to be changed.
Return to Function 00.
Short PRESS
Long PRESS
Increase the Function Value.
Increase the Function Value times ten.
Numeric Keypad Short PRESS Change the Function Value. (WC30 only)