Filter
Top Products
LiteRider™ Owner’s Manual Rev.A_122810
V. OPERATION
SEATING
Armrest Width Adjustment
To adjust the armrest width:
1. Loosen the adjustment knobs at the rear of the seat.
See #1 on figure 6.
2. Slide the armrests in or out to the desired width.
3. Tighten the adjustment knobs.
Be sure adjustments knobs are securely
tightened against the inserted armrest tube. Do not
exceed the maximum armrest width of 24 in.
Flip-up Armrests Figure 6. Armrest Width Adjustment
Pull up on the end of either armrest to flip it up
for easy transfer on and off your Golden LiteRider™.
See #1 on figure 7.
Armrest Angle
To increase the armrest angle, turn the armrest
angle screw counterclockwise. See #2 on figure 7.
To decrease the armrest angle, turn the armrest
angle screw clockwise.
Seat Rotation Lever
The seat can be rotated through 360° and locked at
any 45° position.
1. Push down on the seat rotation lever and rotate
the seat to the desired position. See #1 on figure 8.
2. Release the handle to lock the seat at any Figure 7. Flip-up/Angle Adjustment
45° position.
Seat Height Adjustment
To adjust the seat height:
1. Lift the seat up and off of the seat pedestal.
2. Remove the nut and bolt that holds the seat
post in the seat pedestal. See #2 on figure 8.
3. Position the seat post at the desired height
while aligning the holes in the seat post and
the seat pedestal.
4. Reinstall the nut and bolt.
5. Replace the seat back onto the seat pedestal.
Figure 8. Seat Height/Rotation Adjustment
18
1
1
2
2
1