Filter
Top Products
ANSI X3.28/SRIO DPA
CONFIGURATION GUIDE
GE Energy Services
Restricted A071-0CG-2.02-2
Full
13
Can't set communications timers
Cause:
• The system was unable to configure the port timers.
Remedy:
• Contact the Customer Service Department to report this error.
Can't set configured bit rate
Cause:
• The system was unable to initialize the port using the configured baud rate.
Remedy:
• Refer to the chapter entitled Configuring the Main Table (A071MAIN) and ensure the
configured baud rate is valid.
Can't spawn/activate E071 process
Cause:
• The system cannot create the Event handler process.
Remedy:
• Contact the Customer Service Department to report this error.
Can't spawn/activate L071 process
Cause:
• The system cannot create the LRU process.
Remedy:
• Contact the Customer Service Department to report this error.
Can't spawn R071 process
Cause:
• The system cannot create the Receiver process.
Remedy:
• Contact the Customer Service Department to report this error.
Can't spawn T071 process
Cause:
• The system cannot create the Transmitter process.
Remedy:
• Contact the Customer Service Department to report this error.