Filter
Top Products
Restricted A071-0CG-2.02-2
Full
9
Chapter 4: Configuring WESMAINT for
the ANSI X3.28/SRIO DPA
This chapter describes how to configure the WESMAINT application to allow ANSI
X3.28/SRIO DPA user's access to the ANSI X3.28/SRIO DPA custom WESMAINT screens.
4.1 Log-In User (B014USER)
B014USER contains WESMAINT application access information for individual users. The
B014USER table is part of the WESMAINT configuration, B014, and is mentioned here for
completeness only. It is not part of the ANSI X3.28/SRIO DPA configuration, but must be
configured if any of the desired options are required for the ANSI X3.28/SRIO DPA custom
WESMAINT menus.
The application control parameters in B014USER are used to provide users access to the ANSI
X3.28/SRIO DPA custom WESMAINT screens. The first application control parameter is the
application number. For control of the ANSI X3.28/SRIO DPA it must always be 71. The second
parameter is the modify access flag and the third is the read- access flag. A description of the
read flags used by the ANSI X3.28/SRIO DPA is shown in Figure 2. All unmarked bits are
unused, and should be set to zero. The ANSI X3.28/SRIO DPA does not use any of the modify
access flags.