Filter
Top Products
7 Display Functions
The insturment operates in any of several modes which determine what infor
-
mation is visible in the lower alphanumeric portion of the display. The MODE
button sequences through the menu functions. This button can be pressed re
-
peatedly until a desired mode is set. The various modes are listed below in the
order they appear. Also refer to Figure 8.
Blank - No data shown
Min/Max - Display minimum and maximum measurements (CLR to re
-
set)
Demand Logging - Store readings (up to 100) on demand in the memory
registers
Auto Logging - Store readings (up to 10,000) automatically in memory at
user selected intervals
Delta(x) - Display delta from reference measurement (ENT to set refer
-
ence)
Units: C/Ω/F/K/R - Set the units of measurement
Rate: 00000 - Set the period for serial transmission
Resol: XXX.XXX - Set the display resolution
CAL MODE - Set probe and instrument calibration parameters (MODE
button must be held for three seconds)
Note: Units, Rate, and Resol are temporary modes. The instrument returns to
Blank mode if left in any of these modes when the power is cycled.
31
7 Display Functions