Filter
Top Products
support.dell.com Service Information for Technicians 7-17
7. Push the module to the back of the bay until it is seated in the connector.
The module is seated when its front plate is even with the neighboring
components.
8. Using a Phillips-head screwdriver, tighten the captive screw at the top of the
module to secure the module to the chassis.
9. Reattach the SCSI cables to the module(s).
5HPRYLQJDQG5HLQVWDOOLQJWKH&RPSRQHQW
0RXQWLQJ%UDFNHW
To remove and reinstall the component mounting bracket, perform the following
steps:
1. Remove all power supplies from the back of the storage system (see "Replacing
the Power Supply," found earlier in this chapter).
2. Remove all cooling fans from the back of the storage system (see "Replacing a
Cooling Fan," found earlier in this chapter).
3. Remove the enclosure module(s) (see "Replacing an Enclosure Module," found
earlier in this chapter).
4. Using a Phillips-head screwdriver, remove the two screws that secure the com-
ponent mounting bracket to the chassis (see Figure 7-9).
5. Lift the component mounting bracket slightly and slide it out of the chassis.