Filter
Top Products
Page 25
Problem Possible Cause Possible Solution
Re-configure controller
Inspect and replace jumpers in proper
configuration
Verify interlock signals are present as required
Inspect relays and replace if failed
Inspect harness and replace if failed
Adjust stow height lower
Grind clearance for nuts
Re-configure controller
Inspect harness and replace if failed
Re-configure controller
Inspect harness and replace if failed
Controller not configured
properly
Jumpers loose or fallen off
controller terminals
Interlocks not installed/con-
nected correctly (Park,
Manual Release)
Controller relay failure
Electrical harness failure
Front cover edge is hitting the
screws/nuts of the platform
hinge assembly
Controller not configured
properly
Electrical harness failure
Controller not configured
properly
Electrical harness failure
Ramp/controller will not
respond or function to
inputs properly
Panel binds on front
cover during stowing
sequence
Pressure mat will not
respond or function
properly
Sensitivity edge will
not respond or function
properly
Troubleshooting
Troubleshooting Guide